Quick Mask Tool

I need help with my quick mask tool. I must have 'done' something to change how it works because now when I use it, the pixels are not completely selected.

I press the quick mask button and paint the area i want to mask. Then when I have finished, I go back to normal mode. I usually push 'SHIFT' + 'CTRL' + 'I' to invert my selection and then delete everything I didn't mask however, now when I try to invert, I get the message 'No pixels are more than 50% selected'. I WANT THIS TO GO AWAY!

I have already tried to reset my tool default with no luck. Can anyone help?


Signed,

Stuck and Sad

i THINK it could be one of 4 things i could think of ...

1. Make sure you are using a solid brush
2. Check that your opacity if you are using a brush that it is at %100
3. Flow should be %100 too.
4. Mode "Normal"

Good luck

Yeah it sounds like you are using less then 50% opacity.

And if all that is correct, and I continue to have this problem? I fear I may have to uninstall and re-install...