Page Corner Flip

Hello; I hope I have the right forum and that my question is not too basic.

On a page, I am trying to turn up one corner so that I can put a logo (or other small image) on the page that the upturned corner reveals.

In other words, one page is on top of another. I want to turn up (or curl back) a corner of the top page to reveal the exposed area on the 2nd page.

I'm using photo shop 6 on a PC. Any directions would be helpful.

Thanks!

Hi there, I'm not sure if the attached example is what you'reaiming for but to create it I made a new document (size will depend on what you are using the image for) created a new layer, used the rectangle tool to make my page then made a copy of this layer so they were both identical.
Now because we are working with paths here I took the top layer and added two anchor points where the top sheet starts to lift away from the bottom sheet on top and left side of the image then with the direct selection tool still selected took the anchor point top left and pulled it diagonally down to bottom right to give the illusion of bending up and back.
I then placed a layer between the two sheets of paper and made another selection for the bottom side of the top sheet.
Colours and logo are off course your preference but I just used out of the box styles.
I hope it makes some sense to you and is useful.



Cheers

D......

I've used this one:

http://www.grafx-design.com/15photo.html

Thank you both....wonderful replies!

Patrick